:	Jun 30, 2004

:

The CKP sensor is located on the LH side of the torque converter housing.

.

Disconnect the battery ground cable.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the exhaust system.

.

: Before the disconnection or removal of any components, ensure the area around joint faces and connections are clean. Plug any open connections to prevent contamination. Remove the CKP sensor.   Disconnect the electrical connector.   Remove the bolt.

.

To install, reverse the removal procedure.   Clean the component mating faces.   Tighten the Torx screw to 8 Nm (6 lb.ft).

.

Install the exhaust system.

.

Connect the battery ground cable.